|
|
|
WATERWAY 2-1/2" POLY GUNITE
JET FITTINGS

1 Hang Gunite Poly Jet Body with
ties through preset holes onto steel rebar. 2
Estimate needed length of 21/2"
pvc pipe by thickness of wall. Cut 2-1/2" pvc pipe at least
4" longer than estimated. Then glue 2-1/2" pvc pipe to Jet
Body. 3 Glue 2-1/2" cap onto end of pipe
for pressure test before guniting. 4 After pool guniting, scoop around
pipe. Before plastering, cut the 2-1/2" pvc pipe inside the
wall and glue on the Gunite Poly Jet Plaster Niche P/N
425-5030 (not included). Cover niche with tape then plaster
over niche. 5 Make a mark on the 1" pvc pipe
flush or even with the end of the 2-1/2" pipe. 6 Unscrew 1" pvc pipe from body and
cut 3-3/8" inward from mark towards retainer ring. Then glue
wall fitting to 1" pvc pipe. 7
Wrap Teflon tape on retainer ring
if necessary and thread the 1" pvc pipe back into body with
Poly Jet Wrench, making sure of a snug fit. 8 If installing any of the internals
above use a poly jet wrench to screw internal into wall
fitting. Also available are metal escutcheons to cover
plastic wall fitting. 9
If installing a deluxe style
internal simply insert into wall fitting and turn clockwise
hand tightening. When tight turn controller counter
clockwise to adjust water flow.








![]()
HOT TUB SPA REPAIR - HOT TUB SPA EQUIPMENT - HOT TUB SPA PACKS - HOT TUB SPA PARTS
POOL REPAIR - POOL EQUIPMENT - POOL VINYL LINERS - ABOUT US - INDEX